Hello! I’m currently working on a project where I need to get some data from a microcontroler. As I’m using a Dynamixel2USB to control a set of servos I would like to connect the OpenCM 9.04 at the same bus emulating a slave with its corresponding ID, etc I haven’t found any project like that bef…

It seems that @Haobot seceded to use DynamixelQ [image] Use OpenCM9.04 as a USB2Dynamixel? Technology Hey guys, I’m also trying to use OpenCM9.04 as a USB2Dynamixel. And here I found a solution from horchler/DynamixelQ and tested successfully with AX-12A servos! [image] …

OpenCM 9.04 as Dynamixel slave?

Technology

Theo March 19, 2018, 10:33am 2

It seems that @Haobot seceded to use DynamixelQ

Topic		Replies	Views
Use OpenCM9.04 as a USB2Dynamixel? Technology software	34	11031	September 5, 2017
Informations about the OpenCM9.04 board and Pypot Technology electronics , pypot , english	2	2152	April 1, 2016
ergo_jr with CM-9 board Support	6	1741	June 30, 2015
What if you had much faster communication with servos? Technology	22	4862	October 5, 2016
[CFC] Sensor board compatible with dynamixel protocol Technology electronics , arduino , english , call-for-contributions , software	3	3320	April 14, 2015

OpenCM 9.04 as Dynamixel slave?

Related topics