Hi, Finally I bought my poppy jr ergo parts and I install OS to Raspberry Pi3. I reach my Jr. http://poppy.local/ and try to configure my motors I open the terminal and write poppy-configure ergo-jr m1 then wait for 15 minutes nothing has happened except Factory reset… How can I fix this probl…

[image] Hakan_Atas: I tried before one hour ago with Raspberry Pi2 and I achieved to configure Motors. Sorry I did not read that you where using a raspberry pi 3 before. Indeed, they change the way they handle serial communication. In order to work with a Pi3, you have to: add enable_uart=1 …

That’s odd. The operation should take a few seconds max. Have you plugged a single motor on the bus while launching the command?

I tried before one hour ago with Raspberry Pi2 and I achieved to configure Motors. Now I have a problem to connect my ErgoJr via Snap what should I write as a host name?

I understand one more time you have to be patient and read more :slight_smile: everything is working for now. Thanks a lot!

Factory Reset problem with Raspberry Pi 3

Support

Theo Split this topic November 7, 2016, 3:58pm 6

2 posts were split to a new topic: Motor configuration problem

Topic		Replies	Views
Poppy Ergo with Raspberry Pi 3 Support	10	3183	June 30, 2016
Making the Ergo Jr work on a Raspberry Pi 3 Support software , blog	0	1257	September 14, 2016
PoppyErgoJr connection with Raspberry Pi 4 Support ergo-jr	4	1108	August 25, 2020
Ergo Jr with Raspberry 3 B+ not connecting to network Support ergo-jr , english , raspberrypi , software	5	862	February 5, 2019
:partying_face: Poppy Humanoid, Torso & Ergo Jr all got a fresh update! Announcements français , english	3	1769	December 12, 2020

Factory Reset problem with Raspberry Pi 3

Related topics